Bring Da Ruckus..! Now A Metruck..!

[nerfbat]

first thing was to swap over front rim/tyre/brake assembly

from this

10" x 2.125" with a crappo tyre

 

to this:

10" x 3" new 90/90/10 road tyre that came with my orders for the Ruckus(never bolted it on her tho)

Edited April 30, 2013 by nerfbat

[nerfbat]

started the strip down of the rear

pretty much where i got to, ran out of light

 

oh put the speedo in the battery box and tidied up the Bars on the ruckus, too

will take a better shot of the setup when i can

[nerfbat]

some idea as to what my plan is

ruck rear, met front like this, looks the secks

Edited April 30, 2013 by nerfbat

[nerfbat]

didnt have to work today so i got stuck into it

Met front with a Ruck rear = Metruck

or the OZ version,

Scoopy front with a Zoomer rear

shall we call it a Scoomer or a Zoopy?

lol

comparison pic of the Met(Right) vs Ruck(Left swingarm

swapping them gives you a nice stretch(Ruck into a Met) or shorter wheelbase(Met into a Ruck), depending on which way you go

the weights in the variator seem fine

all bolted together.

[nerfbat]

got the whole Ruck rear end fitted up, minus the Mojo Customs fatty/extension kit

 

how the ruck front end sits for now...

 

ran out of light to do anymore

fingers crossed, this should be running tomorrow

 

then to get the Rucktro together

:-P

thanks for your time

[nerfbat]

got her running ok, tidied up the wring a bit, still needs more

havent wired up the tail light yet

the blue bag holds the battery, as the battery and ecu are usually in the big box under the seat on a std Met/Scoopy

can't afford to buy anything for a while, but i need paint for her, wire the tail light, and fit the big gun exhaust

wont be fitting the fatty or extra stretch kit til i test it out for a week or so, iron out the bugs, etc

[It's_AUDM_Yo]

So does it just stay registered as a Zoomer? Because its "mostly" Zoomer

Edited May 4, 2013 by It's_AUDM_Yo

[nerfbat]

hi mate, i assume i can as i have kept the frame part with all the Zoomer 'VIN' etc.

once this girl is running right and i am reasonably happy with her, i will start on the Ruckus/Zoomer build

Thanks to Trev(who gave me a huge workbench) and rob who helped bring her over, i now have plenty of space in my shed to 'Bring Da Ruckus..!

[nerfbat]

tail light wired up, and took her for a short ride around the block to test her out

seems ok, but i will need to play with the carby i reckon, rejetting, etc, after removing the big and restrictive air box, and putting the 'Big gun' exhaust on her

[nerfbat]

playing with jets today.. got her running rather nicely

pulls hard up to 60 now, but then sits on the rev limiter at around 70(speedo ends at 60, guessing 70 due to the needle place past the mark), but at least its perfect for town riding

if i get her pulling hard and smooth right through to 65ish, i will then play with the variator/ weights/ ramps and push it a bit

i am noticing a slight hesitation around 35-45 kms, but i found an easy way to space the needle up a bit, enrichening the mixture throughout the rev range

tomorrow, ima try it, and play with the jets more

more pics too

then to paint it all either OD green, or flat back when i can afford it

 

and THEN.... back onto the Ruckus/Zoomer

 

thanks for your time

Edited May 9, 2013 by nerfbat

[nerfbat]

pulled the carby down, put an M25 washer under the needle to increase fuel flow, also put in a bigger jet from the other carb, it now pulls hard up to 60 kms

i didnt take pics of the carb trick, but i found some from the guide i used

 

before

 

washer placed on needle

 

and after

it essentially enriches the mix thrughout the throttle range

will check the plug after a day or so riding and adjust to suit

 

tomorrow the Big Gun exhaust gets fitted properly, which may require a retune of the carb

but I can't wait..!

then paint, and i'll be sorta happy

thanks for your time

[madKE35coupe]

Suprised you havent gone to one of these yet zow :)

[nerfbat]

mate..! thats pure awesomesauce..!

don't tempt, me lol

 

but also, thanks for the pics..! that is pretty much exactly, the colour scheme i am looking for

 

cheers mate

[nerfbat]

hey guys, check this out

http://www.houseofja...gkok-motor-show

concept show reveal a Cali style Zoomer they may be bringing out..!

if so, i am excite..!

GOT FAT?!?

Edited May 10, 2013 by nerfbat

[nerfbat]

couldnt afford paint, so i decided to do it on the cheap with the left over SCA Matt Black paint cans i had, also thanks to Rob for giving me one, doubling my stockpile..lol

these, plus the leg guard panel, are the pieces that got the Wet & Dry treatment

after the first 2 coats

decided i needed to buy more paint after using up the 2 cans i had

sold some of my old games to my mate's cash shop and bought 4 more tins of paint for 10 bucks

so, the paint job cost at most 15 bucks... and I'm sure it will show when i bolt her all together tomorrow arvo

last thing i did was fit a red T10 LED to the cluster, another leftover from the black KE 36 panno

will post more pics tonce i get her back together