flawless-paint Posted October 13, 2012 Report Posted October 13, 2012 Bought a ke20 It's got sr20de 5 spd manual Vl turbo diff 3.45 ... Apparently out of the rb30 ke20 sleepy Custom tailshaft with v8 commodore unis Gearbox tunnel cutout n replaced Bigger 15 inch dragways Run 14.05 at eastern creek 1st and only run . Soon to come Megan coilovers Willwood 4spot brakes 4x114.3 hubs on all 4s Mickey thompson Rear slicks And a 500hp sr20det Quote
the_ke55! Posted October 14, 2012 Report Posted October 14, 2012 Sounds nice, show some pics mate? Quote
Chobis Posted October 14, 2012 Report Posted October 14, 2012 (edited) :POSTPICS!: Subscribed! Edited October 14, 2012 by Chobis Quote
flawless-paint Posted October 17, 2012 Author Report Posted October 17, 2012 a few new bits n pieces came in the mail :) :) Quote
flawless-paint Posted October 17, 2012 Author Report Posted October 17, 2012 (edited) maybee ..still thinking wether or not to put it in.. probably won't need it ... Edited October 17, 2012 by flawless-paint Quote
flawless-paint Posted October 21, 2012 Author Report Posted October 21, 2012 (edited) disconnected motor and gearbox today .... all ready for when the crane arrives tomorrow Edited October 21, 2012 by flawless-paint Quote
Jono.C Posted October 21, 2012 Report Posted October 21, 2012 Defiantly needs a fat turbo sitting in the bay :P Quote
flawless-paint Posted October 21, 2012 Author Report Posted October 21, 2012 don't worry its coming :) bay looks a bit unused without it Quote
Jono.C Posted October 21, 2012 Report Posted October 21, 2012 Looks a bit bare yeah! What's the plan for it? Drags? Circuit? Skids? Quote
flawless-paint Posted October 21, 2012 Author Report Posted October 21, 2012 (edited) bita skids bita drags Edited October 21, 2012 by flawless-paint Quote
timj Posted October 22, 2012 Report Posted October 22, 2012 What brand is the coilovers? Where did you buy them? Quote
flawless-paint Posted October 23, 2012 Author Report Posted October 23, 2012 they're megan coilovers and don't fit ! lol going to take them to get machined tomorrow Quote
timj Posted October 23, 2012 Report Posted October 23, 2012 Ok, What kind of car is it for and what do you have to do to make them fit? (puuuuuuuh that was a lot of todo`s) ;) Quote
flawless-paint Posted October 24, 2012 Author Report Posted October 24, 2012 they're off an ae86 .... theres a few nuts and ball joint spacer that i had to machine so the camber plates fit..... thats just the top bit.... haven't sorted out the bottom yet... that drama will have to wait till after the motor goes in when i end up fitting them .... Quote
flawless-paint Posted October 24, 2012 Author Report Posted October 24, 2012 just took the motor and gearbox out... and paint stripped half the engine bay ready for seam welding Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.