Diy Fibreglass Roller

[towe001]

 

Put simply i needed a fibreglass roller but i couldn't find one so i made one.

 

Some of the items needed -

• M12 x 60mm bolt - nut not needed
  
• Metal coat hanger
  
• Centrepunch
  
• Hacksaw
  
• Drill bit a little bigger diameter than the coathanger
  

Items not shown -

• Hammer
  
• Drill (Preferably a bench/pedestal drill)
  
• Pliers
  
• Vice
  
• Cutting fluid (not needed but it does much life easier for the drill bit)
  

Edit - Cheers carbonboy for pointing out the drill bit size

Edited May 4, 2012 by towe001

[towe001]

Step One

 

Cut the head off the bolt.

 

And use the centre punch

to put some dimples into each end of the bolt.

 

Step Two

 

Time to drill a hole at each end of the bolt.

Cutting fluid will make it easier on the drill bit - run the bit at a slow speed.

 

All going well you'll end up with a hole at each end.

[towe001]

Step Four

 

Cut the coathanger approximately in the same locations.

The bottom half is used, the top half you'll have to hide from the wife.

 

Then the wire is bent into a "V" shape and each end of the wire is inserted into the drilled holes in the bolt.

 

With a bit of bending and twisting to make the handle and to keep bolt in place.

 

 

Only thing to make sure of is that the bolt can spin with some easy.

[carbonboy]

Great work Rob, brilliant idea! I'll be doing exactly this if I can't find mine! :y:

[zeph_KE70]

Wicked!

[flyinwall]

now how in the world did you come up with that idea????? hehehe

[ATOYOTA]

When I read "Diy Fiberglass Roller", this was not what I had in mind...

[tuntown2]

thumbs up!

[scarface4lyf]

When I read "Diy Fiberglass Roller", this was not what I had in mind...

Ye I was kind of disappointed too :((

[67Rolla-Ken]

When I read "Diy Fiberglass Roller", this was not what I had in mind...

Same... being Rollaclub and all.