Weber 32/36 Dgav Water Choke To Manual Choke

[rhys2229]

Hi i recently purchased a weber 32/36 DGAV carby off a rs2000 escort and it doesnt seem to have the water choke assembly attached to it, can i just fit the original manual choke off the aisian carby to it? and do i just block off the original emission hoses? thanks

Edited January 31, 2010 by rhys2229

[Taz_Rx]

Just tube it adequately so you don't need to use the choke!

I doubt you'd be able to adapt the asian one to fit a weber, but you can always prove me wrong!

[shauns ke30]

Hey mate just to let you no i have a 32/36 weber on my 5k and from what i can remeber i have no choke

assembly at all. It never came with one car still starts fine drives fine. just on a cold morning sounds a little

rough but when warm fine :)

 

hope this heaps you?

 

what car/motor is it going on??

[rhys2229]

Hey mate just to let you no i have a 32/36 weber on my 5k and from what i can remeber i have no choke

assembly at all. It never came with one car still starts fine drives fine. just on a cold morning sounds a little

rough but when warm fine :)

 

hope this heaps you?

 

what car/motor is it going on??

 

its on a 82 ke70 with a 4k, i'm just a bit concerned about the choke as i usually need to use it on the stock carby as i go to work at 5:30am, i'll see how it goes without one.

thanks

[shauns ke30]

yeah mate when i had the stocko carb on i had to use the choke too

but like i said my 32/36 weber didnt have a choke assembly when i got it lol

:D

 

but from what i can remember on my old 3k i had a stocko carb with a choke assembly on it

but my choke cable wasent attached to the choke on the craby it was attached

to the excelerator cable :jamie:

 

lol old man before me must off don't some mods :D

 

cheers mate good luck