32/36 4k Install

[OniBerserker]

got myself a 32/36 and I'm a bit stuck in my install

 

i have got to hooking up the acc cable and hoses and i have no idea what I'm looking at.

any helpful info as to what i should be doing with the parts shown in the last pic link.

 

 

http://i135.photobucket.com/albums/q150/ts...on/DSC00062.jpg

http://i135.photobucket.com/albums/q150/ts...on/DSC00063.jpg

http://i135.photobucket.com/albums/q150/ts...on/DSC00064.jpg

http://i135.photobucket.com/albums/q150/ts...on/DSC00065.jpg

http://i135.photobucket.com/albums/q150/ts...on/DSC00066.jpg

 

also should the factory carby plate ( black thing under stock carby) be used with the swap or discarded?

[Palmy]

hey mate, sorry i can't help u much with those parts in ur last pic. but i think the bracket on the right would be 2 hold the acc cable in place.....

about that black plate, i THINK that it is a heat shield, but if it still fits with the weber on i would say jus leave it on...

i have no idea about that tube or the bolt at bottom, my kit is fairly different.

i have the same engine and carby but i havent been able to hook mine up yet as my car is getting resprayed

so i can only limit my knowledge on this lol

I'm sure some other person can help u out more then me... lol

Edited September 1, 2008 by Palmy

[OniBerserker]

well this is what I'm thinking so far,

L bracket bolts onto carby using one of the carby mount bolts, and one of the little bolt things mounts to this L bracket.

other little bolt connects to throttle control. the acc cable is then run through lil bolt one to lil bolt two

but then I'm left with a bracket and a spring.

 

 

 

i seriously need some advice here :P

[johnny t]

the spring is ur return spring for ur throttle johnnyt

[OniBerserker]

ok, figured i don't need the L bracket, just using the other bracket bolted onto the carb mount bolts.

acc cable fis into this, and then run cable through lil bolt thing attached to throttle control.

so i should fit the return spring too the throttle.

 

this is starting to make sense.

 

what are the vacuum lines on the carb supposed to connect to?

[johnny t]

yep i would... i don't on mine and the throttle sticks everynow and again.. i can't find a way to make it work yet.. all mine are bloked off and it runs fine... johnnyt

[OniBerserker]

any of you guys who have hooked up one of these before could you tell me what these 3 vacuum ports should connect to?

 

 

and i ran the return spring to the bottom of the inlet manifold where it used to bolt to factory exhaust manifold if thats any help to you johnny t

 

[Gecko71]

Try

http://stores.ebay.com.au/GEM-PARTS-AUSTRA...ON-DIAGRAM.html

for details on connections & the way to set up your throttle bracket & spring.

[tioklou]

in my opinion you should block the (1) and (3) vacuum ports! the (2) vacuum you must connect it to your distributor!