Electronic Dizy On 4k

[rolla_boy70]

can people please help me i want to put a 5k electronic dizzy on my 4k but i don't know exactly all the parts i need.

 

could some one tell me in a list of what all the parts i need and about how much they cost

 

cheers David

Edited October 21, 2007 by rolla_boy70

[Hiro Protagonist]

can people please help me i want to put a 5k electronic dizzy on my 4k but i don't know exactly all the parts i need.

 

could some one tell me in a list of what all the parts i need and about how much they cost

 

cheers David

 

It depends on which distributor you have. By the sounds of it, you have one with an internal ignitor. Therefore, you only need rotor, cap and leads (the leads could be the same as the old 4k ones anyway). All you need to do is line the engine up with TDC on cylinder 1, undo the bolt and pull out the old dizzy, set the rotor on the new dizzy to point to roughly the same place, and bolt it in. The two wires which come from the dizzy go to the positive and negative sides of the coil. Then do the timing as you would on any other engine. The only problems which might arise is that the new dizzy could have two vacuum ports instead of the old one, and that the oil-pump key may make the dizzy slot in out of alignment. This is simply a case of trial and error, using a long flat-blade screwdriver to rotate the oil-pump with the dizzy removed, and then re-inserting the dizzy.

[Taz_Rx]

Hey Hiro, I noticed you did the 4keu dizzy upgrade in your projects thread.

I just bought one too (well its a 4k elec dizzy, so assuming the same) and just wanna know a couple of things:

Do you know which wire is neg and pos? Like what colours are they?

And do you possible have a part number for the rotor cap and button?

[kangaroosa]

Mine has:

Black Wire - Negative

Black Wire / Orange Stripe - Positive

[Hiro Protagonist]

Hey Hiro, I noticed you did the 4keu dizzy upgrade in your projects thread.

I just bought one too (well its a 4k elec dizzy, so assuming the same) and just wanna know a couple of things:

Do you know which wire is neg and pos? Like what colours are they?

And do you possible have a part number for the rotor cap and button?

 

 

Can't remember part numbers for the cap and button. I just took the dizzy into Bursons and they fished around in their stock and looked up the catalogue till they found something that fit. From memory they came from something like a 5K Liteace

[wanzl]

hey guys could you send me in the right direction for where

to read up about electronic distributers thanks

[jono1986]

What do you need to know, cause there's google or

 

http://www.rollaclub.com/board/topic/46089-how-to-install-an-electronic-distributor/

[Taz_Rx]

What do you need to know, cause there's google or

 

http://www.rollaclub.com/board/topic/46089-how-to-install-an-electronic-distributor/

 

Don't get too cocky, he dug up a thread from 2007 so he did obviously searched! :wink: