Jason Posted January 19, 2007 Report Posted January 19, 2007 I tried starting my car. I had goten a ballpark injector timming. I tried starting it. It went pop pop pop Ajusted them again and no mater what i carnt get it to even get it to pop. NO fuel is getting into the cylinders. Ive taken the rail off to look for blockages, but no its perfect. When the ecu is on in 'run' i pulled an injector out and pluged it in and it did not humm? They are low impendece ones 3.1ohms ive had the cleaned and benched tested all of them came to 390cc/m HELP and i am getting a HZ out of the plug and about 5v (comes down becuse of pulse withd assuming) Quote
Teddy Posted January 19, 2007 Report Posted January 19, 2007 Jason, Try posting this on the megasquirt forums as well if u havnt already. Quote
Medicine_Man Posted January 19, 2007 Report Posted January 19, 2007 can you feel the pump pressurise the fuel line before the fuel rail? Quote
Teddy Posted January 19, 2007 Report Posted January 19, 2007 fuel rail is pressurising, quite nicely :jamie: Quote
NickZ Posted January 19, 2007 Report Posted January 19, 2007 Is the engine block grounded and is the ground of the ECU to the engine block as well, One side of the injector wiring should read 12V +, the ECU will switch to ground, They shouldnt hum, it will only pulse when you have a ignition pulse, kill the fuel pump and coil, Pull a injector and plug it in holdit and get someone to turn it over and feel is its pulsing. Quote
Jason Posted January 19, 2007 Author Report Posted January 19, 2007 will do. The block is well grounded, but i might run another ground from the bloack to the ecu. I'm going to try flashing the ecu again, something happened after the 1st attempt (laptop froze) so I'm gona try it and see what happens Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.